Oger - GIS Umwelttechnik EN

Height of the stop bar max. 160mm
Total height: 220mm
Stop bar: Ø 8mm
By the two joint sockets and a 360 ° rotating head almost every setting imaginable situation.

The nut is used without change for 16, 18 and 20mm wide T-slots. At 10, 12 or 14mm wide T-slots, you would have to adjust the nut accordingly. This is possible because the nut has an M8 thread and this one allows milling of surfaces up to 10mm.

If the height of 160mm may be too low, you could have a correspondingly high surface between the machine table and workpiece stop mount (eg square footage 40x40x70mm).